Specification | OptiXaccess EA5801S-FL16 |
Dimensions (H x W x D) (mm) | 400 x 300 x 120 |
Weight | About 15kg |
Power supply mode | • DC power supply |
• AC power supply | |
Rated voltage | • DC power supply: –48 V to –60 V |
• AC power supply: 100 V–240 V | |
Maximum input current | • DC power supply: 6 A |
• AC power supply: 2.5 A | |
Protection rating | IP65 |
Surge protection level | • AC power port: 20 kA in difference and common modes |
• DC power port: 10 kA in differential mode and 20 kA in common mode | |
Operating temperature | –40°C to +50°C (with solar radiation); minimum startup temperature: –25°C |
Operating humidity | 5% RH to 95% RH |
Atmospheric pressure | 70 kPa to 106 kPa |
Altitude | • Below 4000 m |
• NOTE | |
• The air density varies with the altitude, which affects the heat dissipation | |
• capability of devices. Therefore, the operating temperature of the device | |
• changes with the altitude. | |
System switching capacity | 460 Gbit/s |
MAC addresses | 32767 |
Access ONT | 2048 |
IPv4 routing table | 8192 |
IPv6 routing table | 4096 |
ARP table | 16384 |
10GE/GE upstream ports | 4 |
Service ports | 16 Flex-PON |
Power consumption | • Static Power Consumption: |
DC power supply: 64 W | |
AC power supply: 65 W | |
• Typical Power Consumption: | |
DC power supply: 115 W | |
AC power supply: 120 W | |
• Maximum Power Consumption: | |
DC power supply: 132 W | |
AC power supply: 135 W | |
• NOTE | |
• The power consumption of the device is calculated based on the following conditions: | |
Static power consumption: 25°C, no optical module in any optical port, and no service running. | |
Typical power consumption: 25°C, 4 x 10GE upstream transmission, 16 x XGS COMBO ports, full service configuration, and full traffic. | |
Maximum power consumption: 50°C, 4 x 10GE upstream transmission, 16 x XGS COMBO ports, full service configuration, and full traffic |
Our address
5AF Whole Floor, 6F605 Room, 30F Whole Floor, xingguang Yingjing Building, No. 119 Shuiyin Road, Yuexiu District, Guangzhou.